ENGINE
Camshaft and Camshaft Oil
Plastic hammer
side
Exhaust side
Slits
01
Dowel pins
Exhaust side
Intake side
I
REMOVAL SERVICE POINTS .
EX HA US T
CAMSHAFT SPROCKET
Use a wrench at the hexagonal part of the camshaft
(to prevent the crankshaft from turning) to loosen the
camshaft sprocket bolt.
(2) Remove the camshaft sprockets.
FRONT CAMSHAFT BEARING FRONT CAMSHAFT BEARING
BEARING BEARING
(L.H.) (L.H.)
(1) Loosen the bearing cap installation ‘in two or three
steps.
(2) Remove the bearing cap.
NOTE
If the bearing cap is difficult to remove, use a plastic
hammer to gently tap the rear part of the camshaft, and
then remove.
INSTALLATION SERVICE POINTS
INTAKE CAMSHAFT/EXHAUST CAMSHAFT
INSTALLATION
(1) Install the camshafts on the cylinder head.
Caution
Do not confuse the intake side and the exhaust side.
NOTE
Install new camshafts using the following procedure.
(1) Remove the rocker arms.
(2) Lay the camshafts on the cylinder head and install
the bearing caps.
(3) that the camshaft can be easily turned by
(4) After’ checking, remove the bearing caps and the
camshafts, and install the rocker arms.
(2) The camshafts dowel pins should be at the positions
shown in the figure.
To Next Page
Loading...
