Oil and
Oil pan side
R E M O V A L
(1) Remove the transfer
shaft still installed..
(2) Insert a flat-tipped screwdriver or similar
the transfer and transaxle, and remove transfer
the center shaft
. .
(3) Remove the transfer from the propeller shaft.
Caution
Do not tilt the transfer assembly to the rear, or transfer
oil will leak out.
(4) After removing the transfer assembly, insert the special
tool to prevent ‘the oil from leaking out.
(5) Suspend the shaft from the vehicle chassis with
wire: etc.
PAN
After removing the oil pan mounting bolts; oil
pan with the special tool and a brass bar.
Caution
Do it slowly to avoid of the
INSTALLATION SERVICE POINTS
OIL PAN INSTALLATION
Caution
After cleaning the oil pan mounting bolt holes in the oil
seal case, the oil pan should be fnstalled.
GASKET INSTALLATION
Replace the gasket and install it in the direction shown in
the illustration.
TSB Revision
. . .
To Next Page
Loading...
