Cylinder Head
CYLINDER HEAD GASKET
REMOVAL AND INSTALLATION
Pre-removal Operation
l
Fuel Line Inner Pressure Release
(Refer to GROUP On-vehicle
l
Engine Coolant Draining
(Refer to GROUP 00 Maintenance Service.)
l
Engine Oil Draining
(Refer to GROUP 00 Maintenance Service.)
3.6
2.9 Nm
2.2
4.9 Nm
22
01
Removal steps
1. Accelerator cable connection
(Refer to GROUP 17 On-vehicle
Service.)
2. Air hose
3. Idle air control motor connector
4. Knock sensor connector
5. Heated oxygen sensor connector
6. Engine coolant temperature gauge
unit connector
7. Engine coolant temperature sensor
connector
8. Ignition power transistor connector
9. Throttle position sensor connector
10. Capacitor connector
11. Manifold differential pressure
sensor connector
12. Injector connectors
13. Ignition coil connector
Engine oil
,
21
14. position sensor connector
15. Crankshaft sensor
16. Air conditioning compressor
c o n n e c t o r
17. Control wiring harness
18. Center cover
19. Spark cable
20. Brake booster
21. High-pressure fuel hose connection
22. Fuel return hose connection
23. By-pass valve hose connection
24. Water hose connection
25. Vacuum hoses connection
26. Breather hose
27. PCV hose connection
TSB Revision
To Next Page
Loading...
