Cylinder Head Gasket,
Intake side
Front of
engine
Exhaust side
REMOVAL SERVICE POINTS
UPPER HOSE/RADIATOR
HOSE
.
Place mating marks on the radiator hose and the hose clamp,
and then disconnect the radiator hose.
HEAD BOLT REMOVAL
Using the special tool, loosen the bolts in the order shown
in the illustration (in 2 or 3 stages), and then the
cylinder head assembly.
INSTALLATION SERVICE
CYLINDER HEAD GASKET INSTALLATION
(1) all oil and grease from the gasket mounting
(2) Install the gasket to the cylinder block with the identification
mark facing upwards.
HEAD BOLT INSTALLATION
(1) When installing the cylinder head-bolts, the length below
the head of the bolts should be within the
If it is outside the limit, bolts.
(A): 99.4 mm (3.91 In.)
(2) Apply engine oil to the bolt thread and the washer.
.
TSB Revision
To Next Page
Loading...
