Mitsubishi HMA100V Technical Manual

-
48
-
For Home Owners
'10 • HM-T-149
Comfort setting hot water
Comfort setting hot water
The integrated water heater is a coil model and is heated by
circulating water, which is heated by the heat pump.
During “normal” consumption it is enough to run the heat
pump to supply the different tapping points of the house with
hot water. The temperature of the hot water in the water heater
then varies between the set values.
Undersection1.0[N]Hotwatertemp.onpage93thereisa
complete description of menu settings for hot water
temperatures.
Available volume
<HMA100V, HMA100VM>
8ℓ/min
12ℓ/min
16ℓ/min
0
100
200
300
400
500
600
50 53 56 59 62 65
Stop temp. HW (°C )
Supply water volume (
ℓ
)
Hot water volume
*
This graph is based on the following conditions :
Inlet water temperature : 15°C
Outlet water temperature : 40°C
Outdoor air temperature : 7°C
Start temp. HW setting :
55°C (Stop temp. HW setting is 58°C or higher)
Stop temp. HW -3°C (Stop temp. HW setting is
lower than 58°C )
<HMS140V>
MT300
HotwaterSupplyisunlimitedincase8
ℓ
/min at the condition
as the capacity is bigger than hot water supply.
MT500
Prioritizing
When the water temperature in the tankdrops, heat pump
operation shifts to hot water production. In case there is
demand for both hot water and heating/cooling for long time,
operation mode is periodically switched between hot water and
heating/cooling. For details, see Menu 1.0 Hot water temp and
Menu8.5.0Periodsettings.
Extra Hot Water
Inall “Extrahotwater”functions,thetemperatureofthehot
waterincreasestemporarily.Thetemperatureisrstincreased
to an adjustable level by the compressor (Menu 1.5) and then
the electric heater is energized until the water temperature
reaches the stop temperature (Menu 1.4).
Temporary“Extrahotwater”isactivatedmanually,whilsttime
based extra hot water is activated using the settings made in the
control computer.
When:
■ “A”appearsabovethe
icon, temporary extra hot water
is active.
■ “B”appearsabovethe
icon, time based extra hot water
is active.
NOTE
“ Extra hot water” usually means that the electric heater
is activated regardless of Allow add heat setting (menu
8.2.1) and therefore increases the electrical
consumption.
8ℓ/min
12ℓ/min
16ℓ/min
0
100
200
300
400
500
600
50 53 56 59 62 65
Stop temp. HW (°C )
Supply water volume (
ℓ
)
Hot water volume
*
This graph is based on the following conditions :
Inlet water temperature : 15°C
Outlet water temperature : 40°C
Outdoor air temperature : 7°C
Start temp. HW setting :
55°C (Stop temp. HW setting is 58°C or higher)
Stop temp. HW -3°C (Stop temp. HW setting is
lower than 58°C )
TBD
0
50
100
150
200
250
300
350
400
450
50 53 56 59 62 65
12 ℓ/min
16 ℓ/min
Stop temp HW (°C)
Supply water volume (
ℓ
)

Mitsubishi HMA100V Specifications

General

Brand	Mitsubishi
Model	HMA100V
Category	Heat Pump
Language	English