35
SPECIFICATIONS
3.
Inspection and Replacement of Engine Oil
ࠉ
ࠉ
Inspection of Engine Oil
Remove the level gauge and wipe off the tip of
the gauge. Insert and remove it once again
and make sure that the oil gauge indicates
within the range of the upper limit and lower
limit (specified amount). When insufficient,
supply oil from the inlet up to the upper limit of
the oil level gauge and make sure that there is
no oil leakage.
Replacement of Engine Oil
(1) Remove the drain oil plugs (2 places) of the oil
level gauge and the engine oil pan and drain
the drain oil.
(2) Close the drain oil plugs and supply new
engine oil to the upper limit of the oil level
gauge.
- When inspecting or replacing the
engine oil, park the tractor on flat place
and stop the engine.
- The oil level gauge and the tail pipe are
provided nearby. Do not touch the tail
pipe. Also, do not touch the oil level
gauge until it cools down.
1944_0056
Drain Oil PlugsDrain Oil Plugs
Engine Oil Pan
Engine Oil Pan
1944_0055
Fill PortFill Port
1944_0057
Oil Level GaugeOil Level Gauge
[Tractor Right Side]
[Tractor Right Side]
MN00077_A
Oil Level Gauge
Specified Amount
[Upper Limit]
[Lower Limit]
For injury accident prevention
WARNING
To Next Page
Loading...
