V
(2) Wiring
CAUTION
Correctly and securely perform the wiring. Failure to do so could lead to runaway of the
servomotor.
(3) Trial operation and adjustment
CAUTION
Check and adjust each parameter before starting operation. Failure to do so could lead to
unforeseen operation of the machine.
Do not make remarkable adjustments and changes as the operation could become unstable.
(4) Usage methods
CAUTION
Install an external emergency stop circuit so that the operation can be stopped and power
shut off immediately.
Unqualified persons must not disassemble or repair the unit.
Never make modifications.
Reduce magnetic interference by installing a noise filter. The electronic devices used near
the servo amplifier could be affected by magnetic noise. Install a line noise filter, etc., when
there is an influence from magnetic interference.
Always use the servomotor and servo amplifier with the designated combination.
The servomotor's magnetic brakes are for holding purposes. Do not use them for normal
braking.
There may be cases when holding is not possible due to the magnetic brake's life or the
machine construction (when ball screw and servomotor are coupled via a timing belt, etc.).
Install a stop device to ensure safety on the machine side.
To Next Page
Loading...
Need help?
General
