Chapter 9 Brakes
1
2
3
4
7J-
Reservoir cap
Fiuid reservoir
Check valve cap
Rear line seat
7.11a Typical earlier model master cylinder-exploded view
5 Check valve 9 Stop bolt . I3 Stopper ring
6 Check valve spring
10 Secondary piston assembly 14 Reservoir hose
7 Valve case
II Primary piston assembly 15 Bracket
8 Master cylinder 12 Piston stopper 16 Chamber covers
17 Master cylinder rebuild kit
7.1
I Fluid level sensor connector
2 Brake lines
3 Connector block
4 Master cylinder
5 Reservoir cap
6 Stop bolt
7 Reservoir
8 Diaphragm
9
Fluid level sensor float
10 Reservoir setil
11 Stop bolt
12 Gasket
13 Stopper ring
14 Primxy piston
15 Secondary piston
1 b Typical later model mask
cylinder - exploded view
16 Before installing the new master cylinder it should be bench bled. Be-
cause it will be necessary to apply pressure to the master cylinder piston
and, at the same time, control flow from the brake line outlets, it is recom-
mended that the master cylinder be mounted in avise, with the jaws of the
vise clamping on the mounting flange.
17 Insert threaded plugs into the brake line outlet holes and snug them
down so that there will be no air leakage past them, but not so tight that
they cannot be easily loosened.
18 Fill the reservoir with brake fluid of the recommended type (see Chap-
ter 1).
To Next Page
Loading...
