Chapter 8 Clutch and driveline
20.6 The right driveaxle is attached to the inner shaft with
20.12 Check the driveaxle axial (end) play with a dial indicator
bolts and nuts (arrows)
21.2 Remove the DOJ outer race circiip with a screwdriver 21.4 Raise the bails with a screwdriver to remove them from
the cage
21.5 Turn the cage IO-degrees to disengage it from the inner
race, then slide it down the driveaxle shaft
20 Front driveaxles (4WD models) - removal and installation
Refer to illustrations 20.6 and 20.12
Removal
1 Raise the front of the vehicle and support it securely with jackstands,
then remove the wheels and the brake caliperassemblies (see Chapter9).
21.6 Remove the snap-ring, the inner race and the circiip
from the shaft
Do notdisconnectthe hosesfromthecalipersanddo notallowthecalipers
to hang by the hoses-suspend them with pieces of stiff wire so there is no
strain on the hoses.
2 Detach the free-wheeling hub cover assemblies and remove the
snap-rings from the end of the driveaxles. Manual hub covers are held In
place with several bolts, while automatic hub covers can be unscrewed
from the hub (see Section 19).
To Next Page
Loading...
