Chapter 4 Fuel and exhaust systems
14.33 Fit the strangler spring to the choke lever 14.34 Align the inscribed line or black painted line of
the choke pinion with the inscribed line on the cam lever
14.35 Temporarily tighten the new lock screws
14.36 Set the choke valve by moving the pinion arm up
or down, align a punched mark on the float chamber at
the center of the three inscribed lines and secure the
pinlon arm with the lock screws
14.37a After installing the choke cover and the new
cover screws, cut off the heads of the A screws. . .
14.37b . . . and peen over the heads of the B screws
Choke valve setting
Refer to illustrations 14.33, 14.34, 14.35, 14.36, 14.37a. 14.37b
33 Fit the strangler spring to the choke lever
(see illustration).
34 Align the inscribed line or black painted line of the choke pinion with
the inscribed line on the cam lever
(see illustration).
35 Temporarily tighten the new lock screws
(see illustration).
36 Set the choke valve by moving the pinion arm up or down, align a
punched mark on the float chamber at the center of the three inscri.bed
lines and secure the pinion arm with the lock screws (see
illustration).
37 Install the choke cover and tighten the lock screws
(see illustra-
tions).
Cut off the head of the A lock screws. Peen the heads of the B lock
screws with a ball peen hammer or punch.
To Next Page
Loading...
