lo-16
Chapter 10 Suspension and steering systems
14.2
/
Rear suspension lateral rod details 2
1 Parking brake cable bolt
2 Lower shock absorber bolt
3 Lower trailing arm bolt
4 Lateral rod
5 Lateral rod bushings
15.3 Rear suspension coil spring details
1 Lateral rod bolt
2 Lower shock absorber bolt
3 Coil spring
4 Spring seaf
5 Axle bumper
sign. Torque specifications must be followed for proper reassembly and
component retention.
1 Raise the vehicle and support it securely on jackstands
2 Support the axle with a jack.
3 Remove the right side lateral rod bolt
(see illustration).
4 Remove the lower left shock absorber bolt.
5 Lower the axle and remove the springs and seats.
6 Installation is the reverse of removal. Tighten the nuts and bolts to the
torques listed in the Specifications Section at the beginning of this Chapter
before lowering the vehicle weight onto the suspension.
16 Rear stabilizer bar (coil spring models) - removal
and installation
Refer to illustration 16.2
Warning:
Wheneveranyofthesuspensionorsteeringfastenersareloos-
ened or removed, they must be inspected and, if necessary, replaced with
newonesofthesamepartnumberoroforiginalequipmentqualityandde-
sign. Torque specifications must be followed for proper reassembly and
component retention.
1 Raise the vehicle and support it securely on jackstands
To Next Page
Loading...
