3. DISPLAY AND OPERATION SECTIONS
3 - 2
Display mode transition Initial display Function Reference
Status display
Diagnosis
Point table setting
Basic setting
parameters
Gain/filter
parameters
Extension setting
parameters
Extension setting 2
parameters
Extension setting 3
parameters
I/O setting
parameters
button
MODE
One-touch tuning
Positioning control
parameters
Alarm
Servo status display.
For the point table method and program
method, "PoS" is displayed at power-on.
Section
3.1.2
One-touch tuning
Select this when performing the one-touch
tuning.
MR-JE-_A
Servo
Amplifier
Instruction
Manual
section 6.2
Sequence display, drive recorder
enabled/disabled display, external I/O signal
display, output signal (DO) forced output, test
operation, software version display, VC
automatic offset, servo motor series ID
display, servo motor type ID display, servo
motor encoder ID display, teaching function
Section
3.1.3
Current alarm display, alarm history display,
and parameter error No./point table error No.
display
Section
3.1.4
Display and setting of point table data.
This is displayed only in the point table
method, not in other control modes.
Section
3.1.5
Display and setting of basic setting
parameters.
Section
3.1.6
Display and setting of gain/filter parameters.
Display and setting of extension setting
parameters.
Display and setting of I/O setting parameters.
Display and setting of extension setting 2
parameters.
Display and setting of extension setting 3
parameters.
Display and setting of positioning control
parameters.
Note. When the axis name is set to the servo amplifier using MR Configurator2, the servo status is displayed after the axis name is
displayed.
To Next Page
Loading...
