3. DISPLAY AND OPERATION SECTIONS
3 - 15
(3) Operation method
POINT
After changing and defining the setting values of the specified point table, the
defined setting values of the point table are displayed. To discard the changed
setting, press the "MODE" button for 2 s or more. The setting before the change
will be displayed. Keep pressing the "UP" or "DOWN" button to continuously
change the most significant digit of the setting values.
(a) Setting of 5 or less digits
The following example is the operation method at power-on to set "1" to the auxiliary function of the
point table No. 1.
The setting value of the auxiliary function of the specified point table No. blinks.
During blinking, the set value can be changed.
Set using the "UP" or "DOWN" button.
Press "MODE" four times.
A point table No. is displayed.
Press "UP" or "DOWN" to select
point table No. 1.
Press "SET" once.
Press "UP" five times.
Press "SET" twice.
Press "UP" once.
Press "SET" to enter.
To the next item setting
………
………
………
Press the "UP" or "DOWN" button to switch to other item of the same point table No.
Press the "MODE" button to switch to the next point table No.
To Next Page
Loading...
