6 - 22 6 - 22
MELSEC-Q
6 PROGRAMMING
(2) Operating the utility package
Operate the utility package on the remote I/O station side.
Set the following in the Intelligent function module parameter setting module
select area.
• Start I/O No. : 20
• Module type : A/D Conversion Module
• Module model name : Q62AD-DGH
(a) Initial setting (see Section 5.4)
Set the initial settings of CH1 and CH2.
Refer to Section 6.5 for the settings.
(b) Auto refresh setting (see Section 5.5)
Set the devices for storing the digital output values, warning output flags,
input signal error detection flags, and error codes of CH1 and CH2.
To Next Page
Loading...
