3 - 1 3 - 1
MELSEC-Q
3 LET'S CREATE AND EXECUTE A PROGRAM
3
3 LET'S CREATE AND EXECUTE A PROGRAM
This chapter describes how to create and execute a program, as well as how to use
basic instructions in AD51H-BASIC.
Please try to actually create a program and test it to see if it yields the proper results.
The procedures described below assume that the following system configuration is
used.
RS-232C/RS-422
interface cable
PLC with
a communication
module installed.
Console comprised of an IBM/AT compatible personal computer
booted with SW1IVD-AD51HP
Please make the following settings on the IBM/AT compatible personal computer and
the communication module.
Communication module • • • • • • • • • • Set the module so that it is in edit mode and
the IBM/AT compatible personal computer is
used as the console.
• The user's manual for each of
the communication modules.
Reference Manual
IBM/AT Compatible
Personal Computer
• • • • • • • • • • • • • Start up the SW1IVD-AD51HP software
package and select the online programming
category so that BASIC can be used in the
communication module's system mode .
• Type SW1IVD-AD51HP Software
Package Operation Manual
(Regarding the startup of the IBM/AT
compatible personal computer)
Reference Manuals
• AD51H-BASIC Programming Manual
(Program Editing/Compiling)
(Regarding AD51H-S3 system mode)
To Next Page
Loading...
