OCT - 2009
TRANSMISSION REFILL KIT
Models: MVA7210, MVA7212, MVA7214
Page
Section
- MV96
- 1
Form 824688
Application Precautions
This equipment is intended for use by vehicle service
professionals with experience and knowledge of its application
and limitations. While it is designed for servicing a variety of
vehicles in a safe and convenient manner, due to variations
between vehicle manufacturers, makes, models and years,
use of this equipment is not always feasible, possible, or
recommended.
Use common sense when operating this equipment. If
something does not seem or feel right, stop immediately and
consult a professional with knowledge of the application. Don’t
force the use of this equipment on an application for which it is
not intended.
The procedures documented in this manual are to serve as
guidelines for general use of this equipment. In addition to
these guidelines, always follow the vehicle manufacturer’s
recommended procedures when attempting to use this
equipment.
Read and understand the instructions for this and all
referenced equipment prior to use.
Always were safety glasses when using this equipment
Instructions for Use
1. Fill the evacuator with as much transmission uid as
required to ll or top-off the transmission. This can be
accomplished by removing the plug from the pour spout in
the reservoir lid and pouring the uid in, or by sucking it in
using the evacuation procedure.
Note: Always refer to the vehicle manufacturer’s
specication for the type of transmission uid to
use.
2. Install and lock the plug in the evacuator pour spout,
and shift the valve on the side of the evacuator to the
DISPENSE position.
3. Insert the transmission rell assembly tube into the 10
mm x 90° pressure/vacuum port located on the top of the
uid evacuator. Push the tube into the connector until it is
rmly seated and secured by the locking sleeve.
4. Select the appropriate transmission rell adapter for the
model of vehicle.
If the rell adapter does not require installation onto
the transmission, connect it to the female quick-change
coupler at the end of the transmission rell tube.
If the rell adapter requires installation onto the
transmission, follow the vehicle manufacturer’s procedure
to do so. Once the adapter is connected to the
transmission, connect the transmission rell tube using the
female quick-change coupler.
5. Open the shut-off valve on the transmission rell
assembly.
6. Pump the evacuator to build pressure and start the ow of
uid to the transmission.
7. Follow the vehicle manufacturer’s recommended
procedure to ll or top-off the transmission to the correct
level, and then close the shut-off valve.
8. Disconnect the rell tube from the adapter by pulling back
on the sleeve of the female quick-connect coupler.
Note: A shut-off valve in the female quick-change coupler
will prevent uid from leaking out of the rell tube
when the adapter is disconnected.
9. Remove the rell adapter from the transmission, and
replace any plugs or caps.
10. Empty and clean the evacuator and rell assembly if
necessary and/or store it appropriately for further use.
MV7201 Evacuator Top View
Evacuator Vacuum/
Pressure Port
Shut Off Valve
To vehicle
transmission
Rell Adapter
(reference)
Female QC
Coupler
To Next Page
Need help?
General
