5. Select type of sequence you’d like to clear and press Confirm button
6. Pass the DTU card on the lock, when you see an orange LED, aim the tablet infrared stick at the lock and press SEND
7. Otherwise if the programming fails the DTU will show “Cannot connect”. To retry programming press SEND twice
6. Set lock clock:
1. Click on DTU software icon
2. Sign in with your staff code and password, then press Login
3. Select IrDA or NFC button and Press OK
4. Press Set Clock menu
5. If the date or time are not right you can change them by pressing the DTU Set Time button, change date or time and
press OK. Otherwise skip this step
6. Press confirm button
7. Pass the DTU card on the lock, when you see an orange LED, aim the tablet infrared stick at the lock and press SEND
8. Otherwise if the programming fails the DTU will show “Cannot connect”. To retry programming press SEND twice
7. Interrogating a lock: (As another option you can make an Interrogation Card)
1. Click on DTU software icon
2. Sign in with your staff code and password, then press Login
3. Select IrDA or NFC button and Press OK
4. Press Lock Log menu
5. Press Retrieve button
6. Pass the DTU card on the lock, when you see an orange LED, aim the tablet infrared stick at the lock and press SEND
7. (Retrieving logs from the lock could will take a few seconds)
8. The screen will display the room no, the door type and date and time when the operation has been done
9. To see the details press room no. (i.e. 101) and choose the event you’d like to see
Note: The tablet will display the last 700 events on the lock and the interrogation card the last 153 events.
8. Lock Indicator Lights:
1. Green solid: Key is valid, lock will open
2. Flashing red: Deadbolt is thrown, room is occupied
3. Flashing green and red: Batteries are running low
4. No lights: Batteries are dead
info@miwacanada.com
www.miwacanada.com
Fax - 450 984 2831
800 724 2910
MIWA Canada
Phone - 450 984 1113
800 724 5904
To Previous Page
Loading...