To Next Page

To Previous Page

4 COPYRIGHT  2016 by MIX s.r.l.REV.05

1-1a. Injury during assembly and maintenance

1-1b. Maintenance must not be carried out with parts connected to the electricity supply and live

and/or pneumatic components pressurized.

1-2a. The actuator is damaged during installation.

1-2b. Only expressly authorised personnel must be allowed to install the actuator.

1-3a. Injury during greasing operations.

1-3b. Greasing must not be carried out with parts connected to the electricity supply and live and/

or pneumatic components pressurized.

1-4a. Intoxication during cleaning.

1-4b. Use of non toxic and non ammable solvents

1-5a. Accidental starting of the electric control panel.

1-5b. The door of the electric control panel is locked by means of a key or a special tool.

1-6a. Contact with damaged electrical cables.

1-6b. Use protective sheaths on cables and xed supports.

1-7a. Electric discharge caused by lightning.

1-7b. Place the appliance in an area protected against lightning, according to regulations. Earth

it to the structure’s earthing system.

In case of electro-pneumatic RAP complete with buttery valve SVA the residual risks to be solved,

in addition to those listed above, are the following:

2-1a. Dangers caused by equipment connected to the actuator.

21-b. The RAP actuator may only be used to operate the SVA buttery valve: there are no dangers

if the instructions given the operating manuals are followed.

2-2a. Injuries to hands and arms introduced into the valve through the upstream and downstream

connections.

2-2b. The connections upstream and downstream should be connected to pipes or hoppers of the

plant (by the installator) and then made inaccessible.

2-3a. Damage from atmospheric pollution due to the leakage of dust through up- or downstream

connections.

2-3b. The up- and downstream connections are to be connected to the plant hoppers or pipes with

seals and thus rendered airtight.

7. Lubrication

The pneumatic actuator is supplied with long-life grease which does not require replacement.Lu-

bricated, ltered compressed air should be used.

8. Technical characteristics

See table TAV. 3-1.

9. Spare parts list

See table TAV. 4-1, TAV. 4-2.

MIX RAP User Manual

Questions and Answers: