MMR SB1000 - Stage Preparation and Installation


Page|13
41 Daggett Drive, San Jose, CA 95134
Phone: +1 (650) 962 9620 Fax: +1 (650) 962-9647 Email: info@mmr-tech.com Web: www.mmr‐tech.com

GeneralOperation
Stage Preparation
1.StageInstallation.

1.1. RemoveaSeebeckStagefromthepackage.

1.2. PutathinlayerofthermalgreaseonthelargeCopperplate(underside).

1.3. Unlock the ZIF connector (if present) on the pre‐amplifier board in the vacuum chamber. Using
thumbsoneachsideoftheconnecter,
inserttheSeebeckstagefully.

1.4. Affix the Seebeck Stage to The Cold Stage by the springfasteners. Be extremely careful! Do not
applyanydownwardforceontherefrigerator.Usetweezerstoadjustthefastenersduringinstallation.
You can move the Seebeck Stage backwards and forwards by a couple
of millimeters to get the best
location.

1.5. LocktheZIFconnector(ifpresent).

1.6. Installthecoveronthevacuumchamber.

2. ConnecttheRibboncablefromtheChambertotheSB1000.IfaK2000ispresentfortemperature
control,ensuretheLinkRibbonCableisinstalledfromthe
SB1000totheK2000.

3. If you are going to use the system at temperatures below ambient, you should also install all
systemcomponentsrequiredforcoolingaccordingtotheMMRRefrigeratorsManual.





