66 67
Polychain
You can connect two COBALT5S devices together to give 10 voices using polychain.
First, connect the desired master COBALT5S DIN MIDI Out to your desired slave COBALT5S DIN
MIDI In.
On the master COBALT5S navigate to ‘Settings (General) > Polychain Master’ and turn this on.
The slave device should now be showing all voice mode LEDs lit and ‘Polychain Slave’ on-
screen.
When In Polychain mode, the slave COBALT5S panel is disabled along with the keyboard.
Polychain mode can be exited by turning off the ‘Settings (General) > Polychain Master’
setting on the master COBALT5S or by rebooting the synthesisers.
Note: Polychain can only be enabled when not in MPE mode
To Next Page
Loading...
