66 67
Polychain
You can connect any 2 COBALT models together to give 16 voices using polychain.
First, connect the desired master COBALT DIN MIDI Out to your desired slave COBALT DIN
MIDI In.
On the master COBALT navigate to ‘Settings (General) > Polychain Master’ and turn this on.
The slave device should now be showing all voice mode LEDs lit and ‘Polychain Slave’ on-
screen.
When In Polychain mode, the slave COBALT panel is disabled along with the keyboard.
Polychain mode can be exited by turning off the ‘Settings (General) > Polychain Master’
setting on the master COBALT or by rebooting the synthesisers.
Note: Polychain can only be enabled when not in MPE mode
To Next Page
Loading...
