2 20’ Predator
INTRODUCTION
Your heavy-duty cutter is designed primarily for weed, grass and brush to 2” diameter. With proper
maintenance as described in the manual, your cutter will provide you with years of dependable
service with a minimum of repairs.
It is recommended that all operators of this implement read this manual or be instructed of its
contents as to safety, proper operation, and maintenance before beginning operation.
Your cutter has been assembled for operation with a tractor PTO input speed of either 540 or
1000 RPM. Should you desire to change PTO input speed, contact you local dealer. This machine is
recommended for use with tractors rated at 50 HP (37 KW) to 120 HP (75 KW) for 540 RPM drive
and 50 HP (37KW) to 140 HP (104KW) for 1000 RPM drive.
When ordering parts for the gear boxes and the drivelines, be sure to specify the serial number.
The serial number is located outside the right tongue attaching plate on the center mainframe
section.
&KDLQJXDUGVGHÁHFWRUVGULYHOLQHLQWHJUDOVKLHOGVDUHVWDQGDUGHTXLSPHQWDQGQHHGWREHXVHGDW
all times.
7RSODFHWKHZDUUDQW\LQWRHIIHFWÀOORXWWKHZDUUDQW\FDUGLQIXOOJLYLQJDOOWKHUHTXHVWHG
information, and mail promptly. Be sure to give the serial number of this cutter.
To Next Page
Loading...