Modern Predator - Page 29

2920’ Predator
Operating Cutter Hydraulics with Three Tractor Hydraulic Ports
Connect one hose into each hydraulic port. Connect lines to correspond with position of hydraulic
control levers.
Operating Cutter Hydraulics with Two Tractor Hydraulic Ports
The lines that operate the wings must be plumbed together and will be controlled using one
hydraulic control valve and the center section with the remaining control valve. Ensure that the
operator is aware that each wing cannot be controlled independently nor will they raise and lower
simultaneously.
Operating the Cutter Hydraulics with a 3-Spool Hydraulic Control Valve (Extra
Equipment)
Ensure the valve matches the hydraulic operating system of the tractor (open or closed center). Refer
WRWKH$VVHPEO\6HFWLRQIRUDGGLWLRQDOLQIRUPDWLRQRQHTXLSSLQJWKHWUDFWRUZLWKDVSRROFRQWURO
valve.
0RXQW WKH YDOYHEDQN WR D WUDFWRU IHQGHU RU RWKHU DFFHVVLEOH ORFDWLRQ &RQQHFW YDOYH EDQN LQOHW
and outlet lines to outlets of the same tractor hydraulic port. Connect the cutter hydraulics to the
FRQWUROYDOYHEDQNZLWKWKHFHQWHUVHFWLRQOLQHWRWKHULJKWSRUW&RQQHFWWKHZLQJF\OLQGHUOLQHVWR
the control valve positioned to correspond with the left and right wing.
7RDFWLYDWHWKHVSRROK\GUDXOLFFRQWUROYDOYHWLHWKHWUDFWRU·VK\GUDXOLFFRQWUROOHYHUEDFNWRNHHS
K\GUDXOLFRLOFRQWLQXRXVO\IHGWRWKHYDOYHEDQN
OPERATION