1.3. How to get your E-bike ready for the road
5
English
YOUR BICYCLE
The following section explains how to get your Saigon E-Bike
ready for riding
Required Tools:
• Allen Key 4-5-6 mm
• Spanner
A. Adjusting the Handle Bar
B. Inflate the tyres
• Recommendation: 35 – 45 psi. Riding the E-Bike with tyres over or under pressure may result to faster deterioration and/or damage.
• We recommend to check the air pressure regularly every 2 - 4 weeks, as bicycle tubes inevitably loose air over time, especially
when not used regularly.
• The bike tyres are not covered by the warranty. However, in the case of a replacement, we recommend to use of the same
KENDA K1172 tyre or a similar high quality tyre of 40mm width.
Step 1. Rotate the handlebars until they
are perpendicular to the wheel and frame
Step 2. Tighten the two lateral screws on
the handlebar using the 5mm Allen key
Step 3. Ensure the top-cap is tight but not
too tight as to cause the handlebars to
feel stiff
To Next Page
Loading...