01/02 AWB8230-1413GB
Technical Data
161
Outputs
Relay outputs programmable as • RUN: Motor operational
• FA1/FA2: Frequency reached/exceeded
• FA3: Frequency reached (1)
• OD: PID deviation exceeded
• OL: Overload
•AL: Fault
• IP: Mains failure
• UV: Undervoltage signal
• RNT: Running time exceeded
• ONT: Mains On time exceeded
• THM: Motor thermal overload
Analog outputs
• Frequency output: I F 1.2 mA, pulse-width modulated (PWM) signal
• Voltage output: 0 to 10 V H, I F 2 mA
• Current output: 4 to 20 mA, load impedance 250 O
The following variables can be output:
• Output frequency, PWM
• Output current
• Output frequency, frequency-modulated (terminal FM only)
•Output voltage
• Power consumption
• Thermal load ratio
• Ramp frequency
Further features (excerpt)
• Automatic voltage regulation
• Unattended start protection
• Variable amplification and output voltage reduction
• Frequency jumps
• Minimum/maximum frequency limitation
• Output frequency display
• Fault history register available
• User-definable pulse frequency:
0.5 to 12 kHz
• PID control
• Automatic torque boost
• On/OFF fan control
• Second parameter set selectable
DF6-340-...
11K 15K 18K5 22K 30K 37K 45K 55K 75K 90K 110K 132K
efesotomasyon.com - Klockner Moeller - inverter
To Next Page
Loading...