Quick Reference Guide
DF6 Frequency Inverter
02/02 AWB8230-1449GB
14
PNU Meaning Value range Def. Setpoint
C001 Function of digital input 1 Function of digital input 1
• 01: REV, anticlockwise operation
• 02: FF1, first fixed frequency input
• 03: FF2, second fixed frequency input
• 04: FF3, third fixed frequency input
• 05: FF4, fourth fixed frequency input
• 06: JOG, jog mode
• 07: DB, DC braking
• 08: SET, second parameter set
• 09: 2CH, second time ramp
• 11: FRS, controller inhibit
• 12: EXT, external fault
• 13: USP, unattended start protection
• 14: CS, heavy mains starting
• 15: SFT, parameter protection
• 16: AT, analog input selection
• 18: RST, reset
• 20: STA, three-wire control start signal
• 21: STP, three-wire control stop signal
• 22: STA, three-wire control direction
• 23: PID, activate PID control
• 24: PIDC, reset integral component of PID control
• 27: UP, remote access, acceleration
• 28: DWN, remote access, deceleration
• 29: UDC, reset frequency with remote control
• 31: OPE, setpoint value through keypad
• 32 to 38: Bitwise fixed frequencies
• 39: OLR, change over current limit
• NO: no, no function
18
C002 Function of digital input 2 Values a PNU C001 16
C003 Function of digital input 3 Values a PNU C001 03
C004 Function of digital input 4 Values a PNU C001 02
C005 Function of digital input 5 Values a PNU C001 01
C011 Digital input 1 • 00: Make contact
• 01: Break contact
00
C012 Digital input 2 Values a PNU C011 00
C013 Digital input 3 Values a PNU C011 00
C014 Digital input 4 Values a PNU C011 00
C015 Digital input 5 Values a PNU C011 00
C019 Digital input FW Values a PNU C011 00
C021 Signal at relay output K23-K24 • 00: RUN signal
• 01: FA1, frequency reached
• 02: FA2, frequency exceeded
• 03: OL, Overload
• 04: OD, PID deviation exceeded
• 05: AL, fault
• 06: FA3, frequency reached (1)
• 08: IP, mains failure, immediate stop
• 09: UV, undervoltage
• 11: ONT, mains On time exceeded
• 12: RNT, running time exceeded
• 13: THM, motor thermal overload
01
C022 Signal at relay output K33-K34 Values a PNU C021 00
C026 Signal at relay terminals K11-K12 Values a PNU C021 05
To Next Page
Loading...
