02/02 AWB8230-1449GB
Standard form for user defined
parameter settings
15
C027 Output, FM output • 00: Output frequency, PWM signal
• 01: Output current
• 03: Output frequency, FM signal
• 04: Output voltage
• 05: Inverter input power
• 06: Thermal load ratio
• 07: Ramp frequency
00
C028 Output, AM output • 00: Output frequency, PWM signal
• 01: Output current
• 04: Output voltage
• 05: Inverter input power
• 06: Thermal load ratio
• 07: Ramp frequency
00
C029 Output, AMI output Values a PNU C028 00
C031 Relay output K23-K24 • 00: Make contact
• 01: Break contact
00
C032 Relay output K33-K34 Values a PNU C031 00
C036 Relay terminals K11-K12, signalling relay Values a PNU C031 01
C040 Overload alarm signal • 00: Always
• 01: Only at constant speed
01
C041 Overload alarm threshold at relay output
K11 to K34
0 to 2 x I
e
[A] I
e
C042 Frequency from which FA2 is switched on
during acceleration
0.00 to 400 Hz 0.00
C043 Frequency from which FA2 is switched off
during deceleration
0.00 to 400 Hz 0.00
C044 PID control deviation
(from the maximum set point value)
0 to 100 % 3.0
C070 Serial interface, programming through: • 02: Keypad
• 03: RS 485 serial interface
• 04: Optional module in slot 1
• 54: Optional module in slot 2
02
C071 Baud rate • 03: 2400 bit/s
• 04: 4800 bit/s
• 05: 9600 bit/s
• 06: 19200 bit/s
04
C072 Address 01 to 32 1
C073 Data word length: 7 or 8-bit 7
C074 Parity • 00: None
• 01: Even
• 02: Odd
00
C075 Stop bits: 1 or 2 1
C078 Transmission waiting time 0 to 1000 ms 0
C081 Compensation of setpoint signal at
terminal O
0 to 65530 Depending
on inverter
model
C082 Compensation of setpoint signal at
terminal OI
0 to 65530
C083 Compensation of setpoint signal at
terminal O2
0 to 65530
C085 Thermistor matching 0 to 1000 105
C086 Offset, AM terminal 0 to 10 V 0.0
PNU Meaning Value range Def. Setpoint
To Next Page
Loading...
