Appendix
01/02 AWB8230-1413GB
176
C070 Programming through:
• 02: Keypad
• 03: RS 485 serial interface
• 04: Optional module in slot 1
• 54: Optional module in slot 2
–02 a current version: ftp://ftp.moeller.net/DRIVES/
DOCUMENTATION/AWB/index.html
C071 Baud rate
• 03: 2400 bit/s
• 04: 4800 bit/s
• 05: 9600 bit/s
• 06: 19200 bit/s
–04
C072 Address, value 01 to 32 – 1
C073 Data word length: 7- or 8-bit – 7
C074 Parity
• 00: None
• 01: Even
• 02: Odd
–00
C075 Stop bits: 1 or 2 – 1
C078 Transmission waiting time [ms] 0
C081 Compensation of setpoint signal at terminal O – Depending
on inverter
model
C082 Compensation of setpoint signal at terminal OI –
C083 Compensation of setpoint signal at terminal O2 –
C085 Thermistor matching – 105
C086 Offset, AM terminal [V] 0.0
C087 Gain, AMI terminal – 80
C088 Offset, AMI terminal – Depending
on inverter
model
C091 Debug mode – 00
C101 Use saved UP/DWN setting
• 00: Use PNU A020
• 01: Use saved UP/DWN frequency
–00
C102 Reset signal
• 00: On rising edge
• 01: On falling edge
• 02: On rising edge, only on fault
–00
C103 Behaviour on reset
• 00: 0 Hz start
• 01: Synchronization to the motor speed
–00
C111 Overload alarm threshold [A] I
e
C121 Zero-point matching, terminal O – Depending
on inverter
model
C122 Zero-point matching, terminal OI –
C123 Zero-point matching, terminal O2 –
PNU Function Units WE Page Setpoint
efesotomasyon.com - Klockner Moeller - inverter
To Next Page
Loading...
