Example for a Text
Operator Panel
12
05/01 AWB27-1302-GB
Transferring the project
to the MI4
To transfer data to the MI4 you will need to
set up a data link between the PC and the MI4
set the communications parameters
change to configuration mode in the MI4.
To set up the connection between the MI4 and the
serial port of your PCs use the ZB4-24A-KP1
configuration cable.
Check the settings of the communications
parameters.
왘 Select ‹ Options
➞
Communication› and set the
parameters in accordance with the following
diagram.
This diagram shows the correct settings for
connecting the MI4-111-KE1 to the COM 1 port. If
you use a different serial connection, you will need to
change the Ports Available parameter accordingly.
If there is as yet no project in the MI4, the unit will
switch directly into configuration mode as soon as
the operating voltage is applied.
To Next Page
Loading...
