Moffat Washtech M2C - Page 2

Distributed in Australia by
M2C OPERATOR TROUBLESHOOTING
 Likely cause  Possible cause
* For issues most likely due to incorrect chemical dosages or other chemical issues, we
recommend you consult your chemical supplier and/or a local chemical expert prior to calling
in a dishwasher technician.
** For issues that are likely due to poor water quality (scale building up, filters being required
on other kitchen equipment etc.), we recommend you consult a local water specialist prior to
calling in a dishwasher technician.
*** To reset the machine after an error message has been displayed, simply turn the machine
OFF and then back ON again. The machine will log the error for future reference.
IF PROBLEMS PERSIST CONTACT MOFFAT SERVICE ON 1300 264 217
Moffat Service 1300 264 217
Parts 1300 263 107
Washtech M2C 1808
Issue Cause
POOR PRE-SCRAPING CARRY OVER OF SOAP FROM SINK OVERLOADING RACKS POOR MACHINE CARE DRAIN UPSTAND NOT PLUGGED IN JETS BLOCKED OR ARMS OBSTRUCTED RINSE NOT WORKING WATER SUPPLY PRESSURE LOW DETERGENT DOSAGE LOW/HIGH* RINSE FLUID DOSAGE LOW/HIGH* POOR WATER QUALITY** RINSE TEMPERATURE LOW <75Ĺ%
DISHES NOT CLEAN
        
STAINING
      
FOAMING
    
PROTEIN BLOOM
       
DIRTY MACHINE
       
FOOD RESIDUE ON WARE
       
FILM/SPOTS ON WARE
       
DETERGENT RESIDUE
   
GREASY FILM/NO FIZZ
    
HIGH DETERGENT USE
   
HIGH RINSE FLUID USE
  
WET WASHWARE
   
SCALE BUILD UP IN MACHINE
 
FILTERS ON OTHER EQUIPMENT

