Need help?Do you have a question about the MoJack EasyStep and is the answer not in the manual?
Unfold one leg of the EasyStep to a 90-degree angle while standing on its side.
Push the safety lock on the leg hinge and unfold the bottom leg portion until straight.
Repeat Step 2 for the opposite leg of the EasyStep.
Rotate the lock until straight and the hook faces out to secure legs in extended position.
Remove the three locking pins from the telescoping arms while the EasyStep is on its side.
Slide telescoping arms up, secure with top pin, and position base locking pins.
Flip the assembled EasyStep to its opposite side.
Repeat steps 5 & 6 to create two climbing support arms.
The EasyStep is now ready to be placed over an obstacle for safe climbing.
To Next Page
General