Molnlycke Avance Solo - Page 6

10 11
Alarms and trouble shooting
Audible and visual display description Possible cause How to troubleshoot
The LEAKAGE
The pump repeatedly alarms with a beep and will then pause.
An air leakage has been
detected.
To correct a leak:
Press around the dressing border and the strips to
improve contact with the skin.
Check that the canister is attached to the pump, that the
canister tubing is attached to the canister, and that the
dressing tubing is connected to the canister tubing.
Press the green start button to restart the pump.
If the leakage is not resolved, the pump will again alarm
for leakage and then pause therapy. If this happens,
contact your healthcare professional.
The BLOCKAGE
The pump repeatedly alarms with a beep and will then pause.
The canister is full or
there is a blockage in
the tubings.
To correct a blockage:
Ensure that the tubing is not clamped or kinked. If the
canister is full, change the canister according to instructions
on page 8 in this document, or in the user manual
(included in the product package) under section 7.3.
Press the green start button to restart the pump.
If blockage is not resolved, the pump will again alarm
for blockage and then pause therapy. If this happens,
contact your healthcare professional.
The LOW BATTERY
When less than 4 hours of battery power remain the LOW BATTERY
alarms with a beep.
The batteries are low. To change batteries:
Change the batteries according to instructions on page
9 in this document, or in the user manual (included in
the product package) under section 7.4. Only use the
product by Mölnlycke Health Care. Press the green start
button to restart the pump.
and the pump repeatedly alarms with a beep.
Alarm for INTERNAL
FAILURE and the pump
cannot be started.
Contact your healthcare professional or
Mölnlycke.
AUDIBLE AND VISUAL DISPLAY
The LEAKAGE indicator
light flashes once every
second.
The pump repeatedly
alarms with a beep and
will then pause.
The BLOCKAGE indicator
light flashes once every
second.
The pump repeatedly
alarms with a beep and
will then pause.
The LOW BATTERY
indicator light flashes
once every five (5)
seconds.
When less than 4 hours of
battery power remain the
LOW BATTERY indicator
light flashes once every
second and the pump
repeatedly alarms with
a beep.
All indicator lights flash at
the same time, once every
second, and the pump
repeatedly alarms with
a beep.
POSSIBLE CAUSE
An air leakage has been
detected.
The canister is full or
there is a blockage in the
tubings.
The batteries are low. Alarm for INTERNAL
FAILURE and the pump
cannot be started.
HOW TO TROUBLESHOOT
To correct a leak:
Press around the dressing
border and the strips
to improve contact with
the skin.
Check that the canister
is attached to the pump,
that the canister tubing is
attached to the canister,
and that the dressing
tubing is connected to the
canister tubing.
Press the green push
button to restart the
pump.
If the leakage is not
resolved, the pump will
again alarm for leakage
and then pause therapy.
If this happens, contact
your healthcare
professional.
To correct a blockage:
Ensure that the tubing is
not clamped or kinked.
If the canister is full,
change the canister
according to instructions
in section 7.3.
Press the green push
button to restart the
pump.
If blockage is not resolved,
the pump will again alarm
for blockage and then
pause ther
apy.
If this happens, contact
your healthcare
professional.
To change batteries:
Change the batteries
according to instructions
in section 7.4.
Only use the type and
model of lithium batteries
specified for this product
by Mölnlycke Health Care,
see section 13.
Press the green push
button to restart the
pump.
Contact your healthcare
professional or
Mölnlycke Health Care.
11 Other information
If any serious incident has occurred in relation to Avance Solo NPWT System, it should be reported to Mölnlycke Health Care.
12 Troubleshooting
During therapy with Avance Solo NPWT System, it is important that you are aware of the audible and visual alarms and
notifications displayed by the pump. This section explains the audible and visual alarms and notifications and gives guidance on
how to troubleshoot and when to contact a healthcare professional.
What do the signals from Avance
®
Solo mean?
The device uses various signals to alert you if it is working or if you need
to take action. Please make sure that you are able to hear and understand the
various signals.
indicator
light flashes once every
The pump repeatedly
alarms with a beep and
The BLOCKAGE indicator
light flashes once every
second.
The pump repeatedly
alarms with a beep and
will then pause.
The LOW BATTERY
indicator light flashes
once every five (5)
seconds.
When less than 4 hours of
battery power remain the
LOW BATTERY indicator
light flashes once every
second and the pump
repeatedly alarms with
a beep.
All indicator lights flash at
the same time, once every
second, and the pump
repeatedly alarms with
a beep.
An air leakage has been The canister is full or
there is a blockage in the
tubings.
The batteries are low. Alarm for INTERNAL
FAILURE and the pump
cannot be started.
Press around the dressing
border and the strips
to improve contact with
Check that the canister
is attached to the pump,
that the canister tubing is
To correct a blockage:
Ensure that the tubing is
not clamped or kinked.
If the canister is full,
change the canister
according to instructions
in section 7.3.
Press the green push
To change batteries:
Change the batteries
according to instructions
in section 7.4.
Only use the type and
model of lithium batteries
specified for this product
by Mölnlycke Health Care,
Contact your healthcare
professional or
Mölnlycke Health Care.
If any serious incident has occurred in relation to Avance Solo NPWT System, it should be reported to Mölnlycke Health Care.
During therapy with Avance Solo NPWT System, it is important that you are aware of the audible and visual alarms and
notifications displayed by the pump. This section explains the audible and visual alarms and notifications and gives guidance on
how to troubleshoot and when to contact a health
care professional.
indicator
light flashes once every
The pump repeatedly
alarms with a beep and
The LOW BATTERY
indicator light flashes
once every five (5)
seconds.
When less than 4 hours of
battery power remain the
LOW BATTERY indicator
light flashes once every
second and the pump
repeatedly alarms with
a beep.
All indicator lights flash at
the same time, once every
second, and the pump
repeatedly alarms with
a beep.
The canister is full or
there is a blockage in the
The batteries are low. Alarm for INTERNAL
FAILURE and the pump
cannot be started.
If any serious incident has occurred in relation to Avance Solo NPWT System, it should be reported to Mölnlycke Health Care.
During therapy with Avance Solo NPWT System, it is important that you are aware of the audible and visual alarms and
notifications displayed by the pump. This section explains the audible and visual alarms and notifications and gives guidance on
how to troubleshoot and when to contact a healthcare professional.
indicator light flashes
When less than 4 hours of
battery power remain the
All indicator lights flash at
the same time, once every
second, and the pump
repeatedly alarms with
a beep.
If any serious incident has occurred in relation to Avance Solo NPWT System, it should be reported to Mölnlycke Health Care.
During therapy with Avance Solo NPWT System, it is important that you are aware of the audible and visual alarms and
notifications displayed by the pump. This section explains the audible and visual alarms and notifications and gives guidance on