• It is strictly forbidden to charge batteries and install them in an electric module if the batteries are
not intended and allowed to be recharged.
• Always dispose of used batteries according to the regulations.
• Remember: do not throw batteries into the re, as it can cause explosions and leaks.
• Check the product for mechanical damage, such as material tears or missing and cracked parts. If
any component raises doubts, immediately discontinue using the product.
IMPORTANT: Always remove and dispose of all packaging, lms, safety features inside the cardboard
box, other plastic components and components that are not approved for use by children. Your child
must not have access to any of the packaging elements and plastic lms, as this can lead to choking or
suffocation. This manual is recommended for future reference, if necessary, to read how to proceed
in case of danger or appropriate maintenance.
REMEMBER: The drawings in this manual illustrate the general use of the product and are for illustra-
tive purposes only. The appearance of the product and its components may slightly differ from the
actual state.
GUARANTEE: The manufacturer provides a 6-month warranty on additional accessories attached to
the product and a 2-year guarantee on the product without accessories.
COMPONENTS OF THE PRODUCT
1. Backrest frame
2. Rear connector tube
3. Right support frame
4. Music box
5. M3*13mm Screw
6. Footrest frame
7. Left support frame
8. Seat pad
9. Toy bar and toys
B.PROPER PRODUCT ASSEMBLY
UNFOLDING:
Press the handle for adjusting the lying position No. 6 by turning the button as shown in the picture.
Next, push the frame until you hear the elements lock with a characteristic clicking sound. Only the
right insertion will ensure that the rocker is secured properly.
HANDLEBAR WITH 3 TOYS
The steel frame has specially made holes on both
sides of the product, into which you have to insert
the handlebar. Once the handlebar is properly
seated in the holes, you can mount 3 toys by
putting Velcro through the holes in the handlebar
BACKREST ADJUSTMENT
The seat backrest has 3 positions that
can be adjusted for inclination. To adjust,
press the buttons on both sides of the
rocker as shown in the picture in the
instruction manual.
ROCKING AND IMMOBILIZING ROCKING
If the plastic movable parts at the bottom of
the rocker frame are retracted, the rocking
function is performed successfully. To
immobilize the rocker, extend the legs from
under the rocker seat.
SAFETY BELTS ADJUSTMENT
To use the product safely for your child, adapt and properly adjust the seat belts, so that there is
10 EN
no slack between the belts and your child when you insert your child and fasten the buckle. Before
fastening the buckle, ensure that your child’s fingers or fabric parts of the child’s clothing do not get
between the buckle parts.
FOLDING THE ROCKER FLAT
Fold down the rocker’s legs, then press the 2 backrest adjustment buttons and change to the lowest
position and move the rotating handle to adjust the lying position (2) and press the second safety lock
(3). After these steps are taken, the product will be folded at and is ready to be carried, stored at or
transported.
SENSORY MODULE
The module is equipped with sounds, lights and
vibrations. In order to activate the appropriate
function, press the buttons accordingly:
a) to activate the sound
b) to activate the lights
c) to activate the vibrations
MODULE BATTERIES: Remember that batteries are not included. It is up to the Customer to purchase
the appropriate batteries. The manufacturer recommends AA, 1.5 V alkaline batteries. Batteries should
be purchased and disposed of according to the information on the battery package. Do not leave the
module with batteries in the sun or in unsuitable conditions to prevent leakage or bursting of batteries.
WARNING: Batteries that are low may cause the malfunction of the sensory module. If any of the
functions cease to work, install new batteries immediately.
11EN
1
2
2
a cb
To Next Page
Loading...
Need help?
General
