• Connect the hose to city/fresh water hook-up located in service center on
the roadside of motorhome.
• The city water valve must remain in closed position.
• Turn on the water supply.
• The water pump can either be in OFF position or in ON position. It will
not affect the water pump to leave it on.
• City/fresh water connection has a built in pressure regulator and one way
check valve that protects motorhome to 45 lbs.
CAUTION: Some water sources develop high water pressure, particularly in moun-
tainous regions. High water pressure is anything over 55 psi (pounds per square
inch). Excessive water pressure may cause leaks in water lines and/or damage the
water heater. Your motorhome comes with a pressure regulator.
---------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------
• Connect the hose to city/fresh water hook-up located in the service center
on the roadside of the motorhome.
• The city water valve must be in the OPEN position.
• Turn on the water supply.
• The water pump should be in the OFF position.
• The fresh water tank has an overflow located on the curbside of the
motorhome. When the water starts to come out the overflow pipe, shut
water supply off as soon as possible.
NOTE: When connecting the motorhome to fresh water be
sure to use a hose manufactured and labeled for potable water
to ensure that the hose will not flavor the water.
--------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------
The purpose of the gravity fill is to be able to introduce
fluids directly into the storage tank. This is very useful for the
dry camper, which can pack and pour bottled water directly in
the hold tank. Being able to add antifreeze for winterization is
made simpler with a gravity fill. You will also find disinfecting
the water system can be made simpler.
1. Locate the fresh water gravity tank fill.
2. Unscrew the cap, taking care to keep it clean.
3. Connect the water hose marked potable water to the
water source.
4. The water hose can stick down inside the gravity fill tube.
5. Turn on the water source, listen to the water rushing inside
the fresh water tank.
6. The fresh water tank is full when water starts coming out
of the gravity fill neck.
Water & LP-Gas Systems
--------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------
EXECUTIVE 4•112
WATER -
CITY HOOK-UP
WATER TANK -
FRESH WATER
FILL
WATER TANK - (FRESH)
GRAVITY FILL
1. Gravity Fill Opening.
2. Vent Opening.
1
2
To Next Page
Loading...
