Chassis Information
--------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------
EXECUTIVE
7•258
Greasing the Driveline Universal Joint:
1. Check the driveline for looseness. If loose, service the driveline as necessary.
2. Apply the specified grease at the grease fitting on the universal joint. Apply grease until the new grease
purges from all the seals.
3. If the new grease does not purge at the seals, loosen the bearing cap bolts and regrease until all four caps
purge. If the new grease still does not purge, replace the universal joint.
Greasing the Driveline Slip Yoke and Splines:
1. Check the driveline for looseness. If loose, service the driveline as necessary.
2. Cover the air hole so that grease can flow easily to the seal. Apply the specified grease at the grease fit-
ting on the slip yoke. Apply grease until new grease purges from the air hole in the end of the slip yoke.
Greasing Intervals-10,000 miles or annual
DRIVELINE
To Next Page
Loading...
