8
To select a flash rate from a Preset (memory) location:
1. Press the ALT FUNCTION button and then the MEMORY button.
2. READ will be displayed.
3. Turn the tuning knob to cycle through the preset flash rates.
4. Once the desired flash rate is displayed, press the MEMORY
button to select it. Press any other button to cancel.
5. DONE will be displayed.
To store the current flash rate in a Preset (memory) location:
1. Press the ALT FUNCTION button and then the MEMORY button.
2. READ will be displayed.
3. Do NOT turn the knob and press the MEMORY button again.
4. STORE will be displayed.
5. Turn the tuning knob to cycle through the memory locations.
6. Once the desired memory location is displayed, press the
MEMORY button to store the current flash rate in that location.
Press any other button to cancel.
7. DONE will be displayed.
Internal “Phase” Delay
Once the flash rate has been adjusted to give a stopped motion image,
the PHASE DELAY button may be used with the knob to increase or
decrease the phase of the reference mark location. Use the PHASE
DELAY button and knob to bring a reference mark, such as a key way,
into your line of sight.
To adjust the “Phase” Delay:
1. Press the PHASE DELAY button.
2. PHASE will be displayed on the bottom line and the current flash
rate will be displayed on the top line.
13
6.0 LAMP AND FUSE REPLACEMENT
6.1 Lamp Replacement
WARNING: Before attempting to remove the lamp, make
sure the stroboscope is turned off and any
mains cord is removed from the AC outlet. Allow
the lamp to cool waiting at least 5 minutes.
The stroboscope is designed to discharge the internal high voltages
within 30 seconds. However, caution should be exercised when replacing
the lamp.
The lamp can be replaced by using just a pocket screwdriver. It is not
necessary to remove any screws to replace the lamp.
To change the lamp:
1. Push apart the two tabs on the side of the reflector housing and
remove the lens using a small screwdriver to help pry one tab and
lift the lens. Take care not to pry the tab any more than is necessary
to free the lens. The reflector is held in place by the front lens and
will come loose, but it is not necessary to remove the reflector.
2. Hold the lamp with a cloth between your forefinger and thumb
and rock it back and forth gently while pulling out. Do not attempt
to rotate the lamp. The lamp is socketed and will come out easily
when pulled straight out.
WARNING: Do NOT touch the new lamp with bare fingers.
3. The lamps are polarized and must be put into the socket matching
polarity. Using a lint free cloth, match up the red dot on the
plug with the red dot on the socket and gently rock the lamp
To Next Page
Loading...