SENSOR DISABLE BY REMOTE (alarm models only)
There are times when you may wish to deactivate sensors (such as the impact sensor) to prevent
false alarms. To turn sensors off, but still arm the rest of the system, press button one to arm the
system and within 3 seconds, press button two. You will hear the siren chirp for arming followed
by three tones indicating the sensors are turned off for this time only. To disable the sensors at
some later time after arming, press the 2
nd
button three times quickly. If the alarm is sounding and
has been triggered by a sensor, pressing the 2
nd
button disables the sensor from further
detections.
PANIC BY REMOTE (in either armed or disarmed state)
In the event of personal attack or you suspect that your vehicle is being tampered with, the alarm
can be ‘panicked’ by pressing button three on the remote for more than 3 seconds. The siren will
sound and the indicators will flash. Press button one to cancel alarm sounding.
IGNITION, BONNET, BOOT & DOORS
When armed, the siren will sound and the indicators will flash for 30 seconds when any of these are
triggered. If a door, the bonnet or boot is left open, the siren will cycle 90 seconds (3 x 30 seconds)
and the indicators will flash. (If programmed for NSW, the siren will sound for 30 seconds once only)
The system does require your vehicle to be fitted with courtesy light door switches for these to
trigger the alarm. Fitting or replacing door switches will incur additional charges.
CHANNEL 2 OUTPUT (eg: BOOT RELEASE – OPTIONAL CONNECTION)
The system provides an output to control features such as a vehicle’s electric boot release if the
vehicle is equipped (a boot release conversion kit is available as an accessory). This may incur
additional charges depending on the vehicle specification.
To activate;
Press button two on the remote for 3 seconds and the boot will unlock and open
The boot trigger circuit and any interior sensor will be bypassed
Upon closing the boot the bypassed circuits will re-arm automatically
8
To Next Page
