1. With oven in standby mode (power on) press “on” button (1).
2. Press program button (11)
Using up/down keys (12) choose the set program required.
Oven will heat to the temperature required. Oven is ready for use when the display
shows the temperature of the program chosen and if steam is required the display
stops flashing.
Note:
If the oven is already hot and the set temperature is lower than the current temperature
of the oven, the door should be opened to allow the temperature to drop.
3. Load oven as required.
To preserve heat, do not leave doors open more than needed to load oven.
4. Press start (3)
Press (13) at anytime during the bake to add 1 minute to the bake time.
5. IF ENABLED IN SETUP. 2 minutes from the end of the bake the buzzer will
sound for 10 seconds. Press start (3) to silence if required.
6. At the end of the bake the buzzer will sound again. Press stop (2).
DAMPER (6) Press to open damper. Press again to close damper.
Red light shows when in open position.
(Closes if left open for 90 minutes)
To Next Page
Loading...
