Turn the power supply on.
This will put the oven in “standby mode” with only the clock showing.
Press clock button (5) and dots will flash under the hours in the time window.
Change value using up/down keys (12).
Press clock button (5) again and dots will flash under the minutes in the time window.
Change value using up/down keys (12).
Press clock button (5) again and day number will show.
Change value using up/down keys (12).
(Usually day 1 is used as Monday)
To save the settings press clock button (5) within 5 seconds.
To set a timer event -
1.Switch the controller into standby( press the I/O button), I.e. only the current time displayed in the
bake time window.
2.Press the bake time button (13) - timer day of week is displayed in temp window (dots appear next
to day) to alter set day use the up/down arrow buttons (12)
3.Press the clock button (5), dots appear next to the hour display - to alter set hours use the
up/down arrow button.
4.Press the clock button (5), dots appear next to the minute display - to alter set minutes use the
up/down arrow buttons (12).
note - if you do not alter the hours/minutes within 6 seconds of selecting, the timer setup
will default back to day setting
i.e. dots appear next to the P - in the temp window, just press the bake time button to get
back to the time setup again.
Setting a time of 00.00 in the timer setup is a non-event so will not switch on the controller.
5. Press the bake time button (13) to save and exit the timer setup .
To Next Page
Loading...
