Monosem NG Plus - Page 41

4 1
o that the machine alays remains oerational and that it assures good erformance, it is essential to roceed to
maintenance orks and regular cleaning.
Every day:
- Empty the hoppers using the aps A. To thoroughly empty the hoppers, it is necessary to carry out some wheel rotations.
- Check the tension and alignment of the chains.
At the end of each season:
- Clean the units with compressed air.
- Check the condition of the down pipes and ensure that they are securely attached.
- Lubricate the variable-speed drive unit via the hole B. Use a synthetic lubricant in an aerosol can e.g. FORCH PTFE Truck
S41.
- I t is essential to clean the chains. Clean the chain with cleaning spirit or diesel. Then lubricate with aTeon-based oil spray
FORCH PTFE Truck S41.
Two aps per unit allow them to be emptied A. There is a discharge opening which allows you to easily empty the Microsem
hoppers C.
To thoroughly empty the units, it is necessary to carry out some wheel rotations.
Use the crank provided to set the ow rate rotation of the engine axle driving gears.
his aliance must be ket dry. t must be emtied at the end of each day.
t must only be used ith microgranules and not ith oders or granules. t is ossible to distribute molluscicides
roided that the insecticide orm system is relaced ith a helicide orm syste.
A
C
B
Szerződésen kvüli fényképek.
Фотографии имет информационный характер.
Non-contractual photographs.