8
A A
The machine should only be used, maintained and repaired by trained employees who are aware of the risks involved. It is essential to respect
the safety regulations mentioned on the machine and accessory stickers and those given in this manual.
Before transporting the machine on public highways, it is essential to ensure that the current Highway Code is observed and that the machine
complies with occupational safety regulations.
olloall recommended recautions
.. see attached recaution sheet.
o not ork under the lanter.
o markers kee clear of the load.
ofding frames kee clear of the load.
AA ecause of its eight, do not leae the later restinga nly on its central drie heels. Attaching or detaching the later
hen the lante ris stacked is strictly forbidden, the later must be unstacked for these oerations.
andling dangerous roducts see instructions of manufacturer.
GENERAL
1 - In addition to the instructions contained in this manual, legislation relating to safety instructions and accident prevention should be complied with.
2 - arnings axed to the machine give indications regarding safety measures to be observed and help to avoid accidents.
- hen travelling on public roads, abide by the provisions of the Highway Code.
4 - Before starting work, it is essential that the user familiarizes himself with the control and operating elements of the machine and their respective functions.
hen the machine is running, it may be too late.
5 - The user should avoid wearing loose clothing which may be caught up in the moving parts.
- e recommend using a tractor with a safety cab or roll bar conforming to standards in force.
7 - Before starting up the machine and beginning work, check the immediate surroundings, particularly for children. Make sure that visibility is adeuate.
Clear any persons or animals out of the danger zone.
8 - It is strictly forbidden to transport any persons or animals on board the machine whether it is in operation or not.
9 - The machine should only be coupled up to the tractor at the specially provided towing points and in accordance with applicable safety standards.
10 - Extreme care must be taken when coupling or uncoupling the machine from the tractor.
11 - Before hitching up the machine, ensure that the front axle of the tractor is suciently weighted. Ballast weights should be tted to the special supports
in accordance with the instructions of the tractor manufacturer.
12 - Do not exceed the maximum axle weight or the gross vehicle weight rating.
1 - Do not exceed the maximum authorized dimensions for using public roads.
14 - Before entering a public road, ensure that the protective and signalling devices lights, reectors, etc. reuired by law are tted and working properly.
15 - All remote controls cords, cables, rods, hoses, etc. must be positioned so that they cannot accidentally set o any manoeuvre which may cause an
accident or damage.
1 - Before entering a public road, place the machine in the transport position, in accordance with the manufacturers instructions.
17 - Never leave the drivers position whilst the tractor is running.
18 - The speed and the method of operation must always be adapted to the land, roads and paths. Avoid sudden changes of direction under all circumstances.
19 - Precision of the steering, tractor adhesion, road holding and eectiveness of the braking mechanism are inuenced by factors such as the weight and
nature of the machine being towed, the front axle stage and the state of the land or path. It is essential, therefore, that the appropriate care is taken for each
situation.
20 - Take extra care when cornering, taking account of the overhang, length, height and weight of the machine or trailer being towed.
21 - Before using the machine, ensure that all protective devices are tted and in good condition. Damaged protectors should be replaced immediately.
22 - Before using the machine, check that nuts and screws are tight, particularly those for attaching tools discs, ickers, deectors, etc.. Tighten if
necessary.
2 - Do not stand in the operation area of the machine
24 - Caution! Be aware of any crushing and shearing zones on remote-controlled parts
25 - Before climbing down from the tractor, or before any operation on the machine, turn o the engine, remove the key from the ignition and wait until all
moving parts have come to a standstill.
2 - Do not stand between the tractor and the machine until the handbrake has been applied andor the wheels have been wedged.
27 - Before any operation on the machine, ensure that it cannot be started up accidentally.
28 - Do not use the lifting ring to lift the machine when it is loaded.
DANGER
To Next Page
Loading...
