Montarbo FIRE PASSIVE MK2 Series User Manual

23 Series FIRE PASSIVE MK2 | Owner’s manual |
Connection panel
[2]
[1]
speakON
®
is a trademark under property of Neutrik
®
AG, registered in US and other Countries.
Warning! Never connect two amplifiers to the same loudspeaker.
[1] Input speakON
®
connector [INPUT]. Connect it to the power amplifier
or to the powered mixer output.
Active terminals are [1+] and [1–].
Terminals [2+] and [2–] are not used.
[2] Input link speakON
®
connector [LINK]. Wired in parallel to the input
connector, making it possible to drive another, parallel connected,
speaker system. Always pay attention to the total impedance.
[!] NOTE: Use only loudspeaker cables (unscreened) having
suitable cross section (at least 2 x 1.5 mm
2
) and quality. Do not
twist or sharply bend the cables and do not allow for knots to be
formed, because they may result in insulation damage.Do not use
shielded cables (microphone/signal cables).

Montarbo FIRE PASSIVE MK2 Series Specifications

General

Brand	Montarbo
Model	FIRE PASSIVE MK2 Series
Category	Speakers
Language	English