Need help?Do you have a question about the Montarbo LM 260 and is the answer not in the manual?
General| Frequency Response | 20 Hz - 20 kHz |
|---|---|
| Dynamic Range | > 110 dB |
| Display | LCD |
| Type | Loudspeaker Management System |
| Outputs | 6 x XLR |
| EQ | Parametric |
| Limiter | Yes, per output |
| Connectivity | USB, RS-485 |
Essential safety guidelines to prevent hazards and ensure proper operation.
Guidelines for proper disposal of electrical equipment and environmental compliance.
General information and welcome to the FiveO by Montarbo® LM 260 processor.
Highlights the digital crossover, EQ, delay, and other processing features.
Explains the use of the USB port for software control and preset management.
Provides instructions for proper physical installation and grounding of the unit.
Details the initial power-on sequence and connection procedures.
Details the meters, display, dial, and control buttons on the front panel.
Describes the output connectors, USB port, voltage selector, and power switch.
Guides through the initial system configuration and loading factory presets.
Explains how to set input gain levels for optimal signal-to-noise ratio.
Covers loading, saving, and naming presets for configuration management.
Details the access level settings and default password for security.
Explains the different operating modes for configuring signal routing.
Displays hardware, software, and serial number information of the unit.
Allows selection of the user interface language for the device.
Adjusts gain, link, phase, and limiter settings for inputs and outputs.
Covers adjusting parametric EQ and crossover filter types and frequencies.
Explains how to set delay times and adjust input mixer levels.
Step-by-step guide for installing the control software and its requirements.
Instructions for connecting and launching the FiveO DSP software.
Overview of the primary screen and its sections in the software.
Explains the X-OVER interface for frequency and slope adjustments.
Details output gain, PEQ, mixer, delay, and limiter configurations.
Illustrates EQ, LPF, and delay settings for low-frequency outputs.
Demonstrates EQ and crossover settings for mid-frequency outputs.
Addresses specific problems and provides steps to resolve them.
To Next Page