Mora MRB221N6BSE - Connecting to Water Supply

You need to purchase several item to4.
complete this connection. You may find
these items sold as a kit at local
hardware store.
Connecting to the water supply
line
1.
First,shut off the main water supply.
3.Connect 1/4"
extension tubing to
shutoff valve outlet.
2.Using the power drill and a 1/4’’ drill bit
drill into the cold-water line and
connect the saddle-type shutoff valve.
2 clips
1/4" extension
tubing
1 Coupler
Cold water line
Pipe clamp
Shut off valve
Flush the tubing. Turn the main water4.
supply on and flush out the tubing until
the water is clear. Then, shut the water
off at the water valve after about a
quart of water has flushed through the
tubing.
Saddle-type
Packing
nut
Outllet valve
Compression
nut
1/4” Extension
tubing
Ferrule (sleeve)
Connect the extension tubing line5.
with the line on the back of the fridge
with the coupler. Fully insert the
extension tubing into the coupler, and
then insert the clip onto the coupler to
lock up the tubing. Do the same with
the other end. After both of clips are
inserted, check the line to make sure it is
held firmly by the clips.
12