18
Seats
The seats in your vehicle are adjustable. Adjustments include fore/aft, rake angle
and lumbar support. Seats should be adjusted to suit the occupant before driving.
To adjust the fore/aft position of the seats, raise the lever located under
the front of the seat. This will allow the seat to slide fore/aft. Once in the
desired position release the lever and the seat will be engaged in position. It is
important to check that the seat is engaged fully in position by attempting to
slide the seat fore/aft without touching the lever.
To adjust the rake angle of the seat, sit in the seat and operate the lever to the
side of the seat base. Any attempt to engage the rake angle lever without sitting
in the seat could result in injury. Please note, the Standard Comfort Seat has a
different rake lever to the one shown in the image opposite.
Back support can be adjusted to provide different pressure, depending on the
level of firmness required.
In the Comfort Plus Seat (image opposite), to increase firmness of the back
section and the side bolsters, squeeze the rubber hand pump furthest away
from the centre tunnel. Press and hold the left valve button below the hand
bulb to decrease pressure in the side bolsters. Press and hold the right button to
decrease pressure in the back section. To increase firmness of the thigh support,
squeeze the rubber hand pump closest to the centre tunnel. Press and hold the
valve button below the hand bulb to decrease pressure in the side bolsters.
In the standard Comfort Seat, back support (lumbar) can be adjusted. To
increase firmness, squeeze the rubber hand pump. Press the single valve button
below the hand bulb to decrease pressure
WARNING Do not adjust the seat position whilst the engine is running.
WARNING Ensure that no objects can be trapped when the seats are
moved / adjusted.
SEATS AND SEAT BELTS
RAKE
RAKE
FORE/AFT
FORE/AFT
DEFLATE
SIDES
DEFLATE
BACK
INFLATE
INFLATE
THIGH
DEFLATE
THIGH
To Next Page
Loading...
Need help?
General
