48
Air Conditioning (AC) (Optional)
The Air Conditioning system in your vehicle is switched on using the push
switch located on the instrument panel. The AC button lights up when
activated. In order for the AC to operate the engine must be running. To have
refrigerated air supplied to the cabin turn the temperature control to the
cold setting with the AC switched on. To supply dehumidified air to the cabin,
have the temperature control turned to a warm setting with AC switched on.
Conditioned air is supplied to the cabin via the outlets in the heater unit.
Temperature Control
To control the temperature of the air being supplied to the cabin, rotate the
knob located on the instrument panel. Turn the knob clockwise to increase the
temperature of the supplied air and anti-clockwise to reduce the temperature
of the supplied air. When Temperature Control is activated an icon will appear
for a few seconds in the Driver Information Panel.
Fan Speed
A rotating knob, located on the instrument panel, controls the rate at which
air is supplied to the cabin. Rotate clockwise to start/increase the flow of air,
rotate anti-clockwise to stop/reduce the flow of air.
Ventilation Distribution
The direction of air being supplied to the cabin is controlled using the vents
located centrally under the dashboard and in the footwells. The under dashboard
vents can be angled to control the direction of the air and can be shut off to
prevent air ventilation coming into the cabin from the heater unit. To activate air
ventilation into the footwells, press the Footwell Vent Switch on the dashboard.
CLIMATE CONTROL AND STARTING PROCEDURE
Starting Procedure
Before attempting to start the car, make certain that the handbrake is fully
applied. Do not operate the accelerator pedal when starting the engine. Turn the
key and ensure that the ignition/steering lock is free. Never allow the car to move
with the steering lock engaged.
To start your vehicle, turn the key to the second position and press the Start
button once to turn on the ignition. Once the ignition is on, depress the brake
pedal (auto) or clutch pedal (manual) and press and hold the start button to start
the engine. Release the button as soon as the engine is running.
If the engine still fails to start, switch off the ignition and consult your nearest
Morgan dealer.
NOTICE Continued operation of the starter will discharge the battery and
damage the starter.
WARNING Carbon Monoxide is dangerous. Do not breathe exhaust
gases, which contain Carbon Monoxide. Before starting any car, be sure
that there is sufficient ventilation to allow gases to escape.
Warming Up
As soon as the engine is running and the instruments are reading correctly, the
car may be driven. The idle speed is adjusted by the engine ECU and may run a
little higher than normal when the engine is cold.
NOTICE Avoid harsh acceleration or labouring at all times, but especially when
the engine is cold. It is recommended that the car be driven carefully until the
normal running temperature is reached.
To Next Page
Loading...
