52
INSIDE: Ensure the hood is folded down. Pull the rear
hood rail release lever next to the drivers seat. The
rear hood rail is released from the back of the vehicle.
Have a helper lift and support the rear hood rail.
Slide the hood cover under the rail, passing the rear
spring catches through the two holes in the hood
cover. Note the press studs should be passed under
the rail to align inside the vehicle, behind the seats.
To avoid potential damage to the vehicle, it is recommended that two people perform the following procedure:
Snap closed all press studs, including those behind
the seats. Push down on the back rail to lock into
place. Remove in reverse order.
WARNING Avoid scratching paintwork with
the press studs.
WARNING The hood mechanism has several
moving parts that can cause injury. Avoid
trapping hands, fingers or loose clothing in the
mechanism while putting up or taking down
the hood.
WARNING It is not recommended to attempt
hood and/or hood cover procedures alone.
HOOD COVER FITTING PROCEDURE
To Next Page
Loading...
