56
Opening and Closing the Bonnets
To open the bonnets on your Morgan first slide the retaining round handle on
the rear bonnet latch down and pull outwards. Repeat the operation on the front
retaining latch and then lift the bonnet upwards. To close the bonnet push down
and inwards on the bonnet latches.
BONNETS AND BONNET STAY
NOTICE Always take care when opening bonnets in windy weather conditions.
The wind may cause bonnets to fall down causing serious injury to yourself or others.
NOTICE Only open one bonnet at a time; opening both bonnets at the same
time may cause damage to the bonnets.
Securing the Open Bonnet
The bonnet stay on your Morgan is located inside the bonnet. To secure the
bonnet using the bonnet stay, place one end of the bonnet stay through
the lower bracket and the other end through the top bracket on the bonnet itself.
NOTICE Take extra care to avoid scratching paint and engine components with
the bonnet stay.
NOTICE Always check the bonnet is supported by the bonnet stay fully
before letting go of the bonnet.
To Next Page
Loading...
