33
Locate the front rail lock/release clamps and squeeze
the clamp and outer lever together.
Make sure both sprung catches are properly aligned
with their holes at the rear of the vehicle. Push down
vigorously over each spring catch to lock in place.
HOOD DOWN PROCEDURE (CONT.)
The press studs are behind the trailing edge of the
doors. Lift the outer ring and pull to release the side
of the hood from the vehicle.
Begin lifting the hood from the front rail. Carefully
make a neat fold through the rear window panel.
FOLD 1
Continue to tilt the hood backwards while making a
second fold between the window and roof section.
Lower the roof fully onto itself, making a third fold.
Make sure all folds are tidy.
FOLD 2
WARNING Ensure the high level brake light is
not covered by the fabric from the hood.
WARNING Failure to release the press studs
before lowering the hood can damage
the vehicle body work.
Lay the clamps flat.
To Next Page
Loading...
