rectangular vents. A small knob on
the vent can be used to open and
close the flaps of the vent to direct air
in the foot wells. These vents can also
be pivoted up and down.
2) On the front of the heater to the
left and right of the control knob, are
two round vents. These can be used
to direct air into the car. The vents are
opened by pressing on the larger of
the flaps. These vents can be rotated
to direct airflow.
Defrost/Demist
An electrically heated windscreen is
fitted to your car to clear the screen in
poor weather.
To operate the screen, first start the
engine as described, then press the
switch on the dash board showing the
screen symbol. This will heat the
eliminates and the screen. In heavy
frost, the screen may take longer to
clear, but should show signs in
approximately 2 minutes.
The screen can be used at all times
when the engine is running, but it is
advisable to switch off the screen
when clear.
Important
Switch off the screen BEFORE
switching off the engine, as this will
drain the battery.
Light and Indicator switch
The left hand control stalk behind the
steering wheel operates the direction
indicators and the vehicle lights.
Indicators
Press the control downwards until it
clicks in place for the left hand
indicators and lift the control upwards
for right hand indicators. The stalk is
fitted with a self cancel system which
should turn the switch off. In certain
cases this may not work if the wheel
has not passed through 90 deg.
Lights
The end of the left hand control can
be rotated upward to operate the
lights.
Position: 1: Lights Off
2: Sidelights and Dash Board
3: Main Beam/Dip Beam
Dip Switch
The same control stalk operates the
dip switch. To change the Head Light
setting, pull the stalk toward the
wheel until it clicks. To change again,
repeat the action.
Windscreen wipers/washers
The right hand stalk behind the
steering wheel operates the wiper and
the washer system.
Wipers: To operate the wipers the end
of the control is rotated upward.
Position: 1: Wipers Off
2: Intermittent Wipe
3: First Speed Continuous
4: Second Speed Continuous
Intermittent Wipe: With the main
switch in the first position, the screen
will be cleared once at a set period.
This period can be varied using the
rotary control on the inner part of the
stalk. The bottom stop is the longest
delay and the top the shortest.
Single Wipe: If the complete stalk is
pressed downward, the screen will be
swept once. The control will return
automatically.
Washers
To wash the screen, the control
should be pulled toward the steering
wheel. The stalk will return
automatically. Each time the washer is
operated, the wipers will sweep the
screen three times.
Caution: Always switch the wipers off
before turning off the ignition. In frost
or snow, always check that the wipers
are free before operation. Not doing
7
Morgan Owner’s Handbook
Operating Instructions
Operating
instructions
Operating
instructions
To Next Page
Loading...
Need help?
General
